ASTM SA333 Pipe Low Temperature Carbon Steel Pipe Round Shape manufacturer from China Zhangjiagang Bonded Area Henglong Steel Tube Co., Ltd.

ASTM SA333 Pipe Low Temperature Carbon Steel Pipe Round Shape

Place of Origin:

Zhejiang, China (Mainland)


	Add to My Favorites
HiSupplier Escrow	Share \|

Product Detail

ASME SA333 Seamless steel pipes for low temperature service

Standard: ASTM A333 / ASME SA333
Stee

ASME SA333 Seamless steel pipes for low temperature service

Standard: ASTM A333 / ASME SA333

Steel grade: alloy steel

A 999/A 999M specification for general requirements for alloy steel pipe

	Grade 1	Grade 3	Grade 6
Carbon, max, %	0.30	0.19	0.30
Manganese, %	0.40-1.06	0.31-0.64	0.29-1.06
Phosphorous, max. %	0.025	0.025	0.025
Sulfur, max, %	0.025	0.025	0.025
Silicon	-	0.18-0.37	0.10 min
Nickel	-	3.18-3.82	-

Process: cold drawn seamless pipe

The tubes cover nominal (average) wall thickness.

Application: Tube for low temperature service

Dimensional range:

OD: 19.05-76.2mm

Any specific size is to be discussed before offer

The tube be 100% eddy current tested

Ultrasonic test is as option

Straightness ≤1mm/1000mm

Roughness: Ra ≤0.8

Mechanical properties

	Grade 1	Grade 3	Grade 6
Tensile strength, min, MPa	380	450	415
Yield strength, min, MPa	205	240	240
	Transverse	Transverse	Transverse
Elongation in 2 in. or 50mm, (or 4D), min, %: Basic minimum elongation for walls 5⁄16 in. [8 mm] and over in thickness, strip tests, and for all small sizes tested in full section	25	20	16.5
When standard round 2-in. or 50-mm gage length or proportionally smaller size test specimen with the gage length equal to 4D (4 times the diameter) is used	20	14	12

Test

One notched bar impact test, consisting of breaking three specimens, shall be made from each heat represented in a heat-treatment load on specimens taken from the finished pipe.
For material heat treated in a batch-type furnace, tests shall be made on 5% of the pipe from each lot. When heat treated by the continuous process, tests shall be made on a sufficient number of pipe to constitute 5% of the lot, but in no case less than 2 pipes.
Each length of pipe shall be subjected to the hydrostatic test or the nondestructive electric test. The type of test to be used shall be at the option of the manufacturer, unless otherwise specified in the purchase order.

Nondestructive Electric Test—Nondestructive electric tests shall be in accordance with Specification A 999/A 999M, with the following addition:

If the test signals were produced by visual imperfections, the pipe may be accepted based on visual examination, provided the imperfection is less than 0.004 in. (0.1 mm) or 12½ % of the specified wall thickness (whichever is greater).

Visual imperfections:

Surface roughness

Straightener marks

Cutting chips

Steel die stamps

Stop marks, or

Pipe reducer ripple

Tubes shall be delivered with square cut ends. The ends are free of excessive burrs.

The tubes are bundled in the waterproof plastic sheet and packed in the wooden cases

The case is most suitable for hanging by forklift.

EN10204-3.1 MTC shall be issued

EN10204-3.2 MTC is as option